the breechblock must fit in the receiver tracks.
Make sure the front action springs fit over
the ends of the action spring guides (See
Figure 13). Push the breechblock in far
enough that the breechblock lever engages,
holding the breechblock in the receiver.
Simultaneously push back on the breechblock
while depressing the breechblock release
button until the notch in the ejection port
lines up with the operating handle recess
on the breechblock. Make sure that the
action springs are compressed inside the
recesses in the breechblock, and that the
ends of the action spring guides start into
40
To Next Page
Loading...