Browning BAR RIFLE - Page 15

5 Perform any clean-
ing of the parts
and receiver cavity
as necessary.
DO NOT DISASSEMBLE
THE TRIGGER GROUP
BEYOND THIS POINT.
TRIGGER
GROUP
REASSEMBLY
1 Before reinstalling
the trigger group,
make sure that the
breech bolt is fully
forward and en-
gaged in the locked
position.
2. Visually check the
safety on the trigger
guard to make cer-
tain it is still in the
ON SAFE position.
3 Insert the trigger
group back into
the receiver, lining
up the holes in the
trigger assembly
with the holes on
each side of the
receiver.
4 Re-insert the trigger guard pins from either side of the receiver and
gently tap them into place again using caution not to scratch the
receiver. (See Figure 8.)
14
FIGURE 7
Remove trigger assembly.
FIGURE 8
Re-insert trigger guard pins.
FIGURE 6
Push trigger guard pins
entirely through receiver.
98355/BAR OM 8/7/03 10:49 AM Page 14