UNLOADING
while unloading your shotgun always plaCe the “safety” in the
on safe position. keep the muZZles pointed in a safe direCtion,
and your fingers away from the trigger. failure to follow
these warnings Could result in serious injury or death.
1 Using your thumb, move the top lever fully to the right to open
the action. Due to tight manufacturing tolerances, it may be
necessary to pull downward slightly on the forearm to completely
open the breech. For proper ejection, keep the receiver level and
allow the barrels to completely drop. This keeps empty hulls in full
contact with the ejectors.
2 It is important to point the breech, by canting the shotgun to the
right (left for left-handed shooters), so empty hulls eject clear of
your body and face. Cynergy shotguns feature automatic ejectors.
Fired shells will be thrown completely out of the gun upon
opening the action; and unfired shells will be elevated above the
chambers for unloading.
INTERCHANGEABLE CHOKE TUBE SYSTEM
never attempt to remove or install a Choke tube in a loaded
firearm. whenever removing or installing a Choke tube in a
shotgun, always keep the muZZles pointed in a safe direCtion.
Completely unload the shotgun. open the aCtion and visually
inspeCt the Chamber, feed meChanism and magaZine to be
absolutely Certain the firearm is Completely unloaded.
always plaCe the "safety" in the on safe position and keep
your fingers away from the trigger. failure to follow these
warnings Could result in serious injury or death.
do not fire this shotgun without the CorreCt Choke tube
installed. permanent damage may result to the threads inside
the barrel.
FIRING
never load a shell into the Chamber or plaCe the “safety” in
the off safe position unless shooting is imminent. always keep
the muZZles pointed in a safe direCtion. failure to follow
these warnings Could result in serious injury or death.
1 Set the barrel selector to the barrel you wish to fire first. By sliding
the barrel selector to the right a “U” will appear signifying that the
under barrel will fire first. If you slide the barrel selector button to
the left an “O” will appear signifying that the over barrel will fire
first. Barrel selection can be made only when the “safety”/selector
is in the rearward, on safe position.
2 When shooting is imminent, slide the “safety”/selector forward to
the off safe position.
3 Take aim and, when ready, squeeze the trigger to fire. After firing
one barrel, it is not necessary to move the “safety”/selector to fire
the second barrel. Simply release the trigger to its original forward
position and pull it a second time. Be certain you fully release the
trigger between shots. If the trigger is not permitted to return to its
fully forward position, the firing mechanism will not reengage.
The subsequent pull will fail to fire the gun. Proper execution of
this maneuver is necessary with any single trigger gun. Failure to
release the trigger ordinarily occurs with overly rapid firing or
heavily gloved fingers.
after firing, or when shooting is no longer imminent,
immediately plaCe the “safety” in the on safe position.
failure to follow this warning Could result in serious
injury or death.
To Next Page
Loading...
