2 Before installing a tube, check the internal choke tube threads in
the muzzle, as well as the threads on the choke tube to be sure they
are clean. Lightly oil the threads with a high-quality, lightweight
gun oil.
NOTICE! failure to Clean and oil the threads on the Choke tube
Could result in the Choke tube seiZing in the barrel.
3 Using your fingers, screw the appropriate tube into the muzzle of
the barrel, tapered end first, notched end outward. When it becomes
finger-tight, use the choke tube wrench to firmly seat the tube.
NOTICE! the Choke tube should be periodiCally CheCked to
assure that it is tight and firmly seated. before CheCking,
follow all Choke tube removal and installation safety
guidelines previously outlined.
ADJUSTING THE COMB
before performing Comb adjustment proCedures, plaCe the
“safety” in the on safe position. open the aCtion and make
Certain your shotgun is Completely unloaded. keep the
muZZles pointed in a safe direCtion. failure to follow these
warnings Could result in serious injury or death.
The buttstock of some Cynergy shotguns feature a comb that can be
adjusted for both cast and drop. These adjustments allow you to
achieve a perfect fit of the stock against your face, and determines how
correctly and consistently your dominant eye aligns with the sight
plane along the barrel rib.
With the gun shouldered, cast off means moving the comb to the
right of the centerline of the gun to give a fit advantage for a
right-handed shooter. Cast on refers to moving the comb to the left
of the centerline, giving a fit advantage for a left-handed shooter.
A shotgun that is correctly adjusted for cast will have you looking
directly down the center of the rib with both the front and middle
beads in exact alignment.
figure 12
RIM
NOTCHES
PATTERN WITH
LEAD SHOT
PATTERN WITH
STEEL SHOT
extended** x-full turkey **
i full *
ii imp. modified
full
1
iii modified
full
1
iiii imp. Cylinder modified
iiiii skeet imp. Cylinder
no notChes Cylinder Cylinder
*
Not for use with steel shot. Using an over-tight choke constriction with
steel shot will result in an ineffective “blown” pattern.
**
Extra Full Special, extended with ports. Do not use with steel shot.
1
When more than one choke designation is listed for a given steel shot
pattern, use the more open choke listed for high velocity, larger shot size
steel loads.
NO NOTCHES
FIVE NOTCHES
FOUR NOTCHES
THREE NOTCHES
TWO NOTCHES
ONE NOTCH
To Next Page
Loading...
