BARREL PORTING
Some Cynergy target models feature ported barrels that reduce recoil
and muzzle jump. Reducing recoil not only increases comfort when
shooting, but increases accuracy because it is easier to pick-up the
second clay target faster due to decreased recovery time following the
first shot. Carbon can build up in the ports after shooting, to clean
them, use a good quality powder solvent and pipe cleaners to scrub
away debris from the ports.
MAINTENANCE OF OIL FINISH STOCKS
Keeping the oil-finished wood surface on your firearm looking its
best requires only a small amount of maintenance. When the surface
becomes spotted or dull, the affected area(s) can be treated using
rubbing alcohol on a soft, lint free cloth and allowed to dry. A small
amount of a linseed oil-based finish, such as Watco
®
Danish Oil Finish,
Deft
®
Danish Oil Finish, or Formby’s
®
Tung Oil Finish should then be
applied to the surface of the wood with a soft, lint free cloth according
to the manufacturer’s instructions. To treat the checkering, a small
amount of oil-based finish can be applied and then distributed evenly
using a toothbrush or other soft bristled brush.
MODELS WITH SPECIAL FINISHES
As with any firearm, the only way to preserve its pristine condition
and collector appeal is to never handle or fire it, which in turn would
deprive you of much of the enjoyment that comes with owning a fine
Browning firearm.
While special finishes such as engraving and gold plating greatly
enhance the aesthetic appeal of your shotgun, please be aware that
they are no more durable, and in some cases may even be slightly less
durable than more common firearm finishes.
As you use your shotgun, you can expect special finishes to wear in
much the same manner as any other firearm finish. These marks are
the honest product of the hours spent enjoying your firearm and each
scuff and scratch will probably have a good story to go along with it.
S E R V I C E O R R E P A I R
If your firearm should require service or repairs, we suggest you first
contact a local recommended Browning Firearms Service Center. To
locate a service center visit browning.com, contact our Customer
Service Department or your Browning firearms dealer for the address
of the Service Center nearest you. Otherwise, you may send your
firearm directly to our Service Department in Arnold, Missouri.
Parts listings, Firearm Service Center lists, service procedures, service/
repair form and general product information are also found on the
internet at browning.com. For technical questions about your firearm
or service, contact:
When returning your firearm for servicing, you must do the following:
1 Be sure it is completely unloaded.
2 Remove the scope or other optics.
3 Package it securely in a cardboard container.
4 Enclose the service/repair form available at browning.com or a
letter that clearly describes the trouble experienced, the
ammunition used and the repairs desired. Also include your name
and a daytime phone number where you can be reached.
5 If convenient, send a copy of the service/repair form or letter
to us separately.
6 Never return ammunition with your firearm. It is against postal
and most commerce regulations.
United States customers contact:
Browning Firearm Status and
Technical Service
One Browning Place
Arnold, MO 63010-9406
Phone: (800) 322-4626
Canadian customers contact:
Browning Canada Sports Ltd/Ltée
5583 Chemin St-François
St-Laurent, Quebec H4S 1W6
Phone: (514) 333-7261
To Next Page
Loading...
