Browning SAFE - Operating and Maintaining Your Safe; Operating the Dial Combination Lock

11
6 Use a 2" wood bit to drill though the fire-resistant insulation. Do
not attempt to drill through the steel safe body with the wood bit.
7 Reposition the safe on your centerline marks against the wall and
mark the hole centers on the wall of the house.
8 Use a
5
⁄16" wood bit to drill the pilot holes through the sheet rock
and stud. Next install
3
⁄8" x 3
1
⁄2" lag bolts through a 1
3
⁄4" diameter
st
eel washer through the safe body and into the stud. Tighten all
anchor bolts.
9 Fill the 2" holes in the safe interior with high-temperature silicone
caulking and reposition the carpeting “X” cut out. The caulking will
hold the carpet in place.
OPERATING THE (DIAL) COMBINATION LOCK
OPENING THE SAFE
1 Turn the dial counterclockwise (left) four times, passing the first
number in your combination three times and stopping on it the
fourth time.
FIGURE 4
Carefully measure the distance between stud centers in your home.
Safe centerline
Stud center
Stud center
05-142-BSF_Safe OM 10/12/05 4:13 PM Page 11