12
2 Turn the dial clockwise (right) three times, passing the second number
in your combination two times and stopping on it the third time.
3 Turn the dial counterclockwise (left) two times, passing the
third number in your combination once and stopping on it
the second time.
4 Turn the dial clockwise (right) until it stops, which is normally
around 95.
5 Turn your safe handle clockwise to open the safe door.
NOTE: If you miss any combination number by more than 1 dial mark
your safe will not open. Make sure you are looking straight down at the
index marks. Make sure to align the numbers with the center index line
located at the 12 o’clock position. If the safe does not open, try turning
the safe handle firmly counterclockwise before dialing the combination.
LOCKING THE SAFE
1 Close the door with the locking bolts retracted.
2 Turn the safe handle counterclockwise (right) to extend the bolts into
the door frame after the door is closed.
3 Turn the combination dial counterclockwise (left) at least three times
to lock the bolts in place.
NOTE: You must first close the door and then turn your safe handle
counterclockwise to extend the bolts before turning the dial to properly
lock the door in place. If the dial is turned while the door is open and the
bolts are extended (handle turned clockwise) the door will be “locked
open.” This is easily fixed by following the unlocking procedure previously
mentioned, immediately followed by the locking procedure listed above.
WARNING: ALWAYS KEEP YOUR SAFE IN A LOCKED CONDITION, EVEN IF
YOUR VALUABLES ARE NOT INSIDE.
LOST COMBINATIONS
You are strongly encouraged to keep a backup copy of your combination
in a hidden and secure location. To protect the safety of your combination,
we will not release combinations without a security check. We do not
05-142-BSF_Safe OM 10/12/05 4:13 PM Page 12
To Next Page
Loading...