14
PAINT
Your painted exterior should be cleaned with a damp soft cotton cloth
only. Do not use solvents or any other chemicals to clean your safe’s
painted surfaces. If you should scratch or chip the paint on your safe, a
touch up bottle with brush is included inside your safe. This bottle should
be adequate for most scratches incurred during installation. Touch up
paint is also available by contacting Browning. However, due to increased
regulations restricting the sending of paint through the mail, Browning
has also provided the Delstar paint numbers for the paint colors available
on our standard safes.
Metallic Black DAR 2945
Hunter Green Metallic DAR 4108
Burgundy DAR 74004
Sand Metallic F1929
FN/Gloss Green DAR 48306
FN/Gloss Black DAR 9000
If touch up paint is needed other than that supplied by Browning, you can
get it at an automotive paint supplier.
NOTE: The textured-finished safe paints are special formulas created by
the manufacturer for Browning/ProSteel and cannot be duplicated by an
automotive paint store. These can be ordered by calling our consumer
department at 1-800-333-3288.
DOOR CLOSURE ADJUSTMENT
Browning/ProSteel safes are shipped with molded door corner protectors
installed between the door corner and the door frame. After removing the
packaging from your safe make sure to remove the protective corners and
adjust the door tension adjustment screw located on the inside of the door
frame (Figure 5). The tension adjustment screw applies pressure against
one of the locking bolts when the door is in the closed position. The
tension adjustment screw should be adjusted until the door closes without
play between the door and frame. DO NOT over adjust the tension screw
or your safe will not close. The locking bolt will hit the adjustment screw.
A
3
⁄16" Allen wrench is required to adjust the tension screw.
05-142-BSF_Safe OM 10/12/05 4:13 PM Page 14
To Next Page
Loading...