Browning T-BOLT - Firing; Preparing to Fire and Post-Firing Actions

17
the rifle is now ready to fire By simPly moving the “safety”
to the off safe Position and Pulling the trigger.
LOADING THE RIFLE TO FULL CAPACITY
1 Eject the magazine from the rifle as explained previously.
2 Pull the bolt completely rearward and inspect the chamber to
make sure it is empty.
3 Close the bolt and place the “safety” in the on safe position.
4 Load the magazine as explained previously.
5 Insert the loaded magazine into the rifle by inserting it into the
magazine well until it is retained in place by the magazine latch.
6 Load the chamber by pulling the bolt fully rearward and then
pushing it fully forward to the closed, locked position to load a
cartridge from the magazine into the chamber.
7 Immediately verify that the “safety” is in the on safe position.
the rifle is now ready to fire By simPly moving the “safety” to
the off safe Position and Pulling the trigger.
8 Eject the magazine from the rifle by pulling the magazine release
button rearward with your index finger. The magazine will drop
into your hand.
9 Load a single cartridge into the magazine as explained previously.
10 Insert the fully-loaded magazine into the rifle.
SINGLE SHOT LOADING FROM THE MAGAZINE
If you wish to use your T-Bolt as a single-shot rifle, it is recommended
that you use the following single-shot loading procedure.
1 Eject the magazine from the rifle as explained previously.