16
that its base is flush with the
rear of the magazine. If the
nose of a cartridge protrudes
beyond the front of the
magazine, it could cause feeding
problems or interfere with the
insertion of the magazine into
the rifle. Continue to load the
magazine in this manner.
5 After loading the magazine,
insert the magazine into the
magazine well of the rifle until it
is retained by the magazine latch.
The bolt may be cycled at any time you wish to load the chamber.
NOTICE!
if the nose of a cartridge Protrudes Beyond the front
of the magaZine, it could cause feeding ProBlems or interfere
when inserting the magaZine into the rifle.
LOADING THE CHAMBER FROM THE MAGAZINE
1 Eject the magazine from the rifle as explained previously.
2 Pull the bolt completely rearward and inspect the chamber to
make sure it is empty.
3 Close the bolt and place the “safety” in the on safe position.
4 Load the magazine as explained previously.
5 Insert the loaded magazine into the rifle by inserting it into the
magazine well until it is retained in place by the magazine latch.
6 Load the chamber by pulling the bolt fully rearward and then
pushing it fully forward to the closed, locked position to load
a cartridge from the magazine into the chamber.
7 Immediately verify that the “safety” is in the on safe position.
figure 10
Rotate the gear located on the right side of the
magazine and insert cartridges.
To Next Page
Loading...