Browning T-BOLT - Cleaning and Maintenance Suggestions; Cleaning Special Finishes and General Procedures

23
with the butt plate and is virtually
imperceptible when shouldering
the rifle.
To remove the magazine just press
downward on the tab above the
magazine (Figure 12). The magazine
will pop into your hand under light
spring pressure.
To replace the magazine insert it
into the buttstock with the rear of
the magazine downward. It will
simply lock into place.
CLEANING AND MAINTENANCE SUGGESTIONS
NOTICE! Please taKe note of the following information Before
cleaning your firearm.
CLEANING PARTS WITH SPECIAL FINISHES
Be especially careful when cleaning firearms with camouflage,
Dura-Touch
®
Armor Coating and other special finishes. Always
prevent these surfaces from coming in contact with cleaning solvents,
barrel scrubbers and other strong chemicals. It is preferable to clean
these surfaces with a lightweight gun oil containing no solvents, or
with a damp cloth and mild dish soap (be sure to keep water out of
the action). When cleaning your firearm’s bore and action, protect the
external finishes from any contact with chemicals used. Also, avoid
any contact between external finishes and other strong chemicals like
those found in DEET-containing insect repellents, sunscreens, etc.
Damage to camouflage, Dura-Touch and other finishes caused by
chemicals is irreversible and not repairable.
Before Performing cleaning Procedures, Place the “safety” in
the on safe Position. oPen the action and maKe certain your
figure 12
Press the magazine latch above the magazine
to eject the magazine from the buttstock.