25
Alternately, the Browning Barrel Weasel
™
makes cleaning the bore
of your firearm fast and easy. Be sure to follow all instructions
when using any product to clean your firearm.
3 Inspect the chamber and bore for powder fouling. A normal
amount of powder residue can be expected and is not serious. It
can usually be removed with a patch saturated with nitro solvent.
If, or when, fouling should become heavy, it can be removed with
a brass bore brush. Dip or spray the brush with nitro solvent
and scrub the chamber and bore until the fouling is removed.
To prevent brass bristles from breaking off, the brush should be
pushed completely through the barrel before being withdrawn.
4 After all fouling has been removed, the chamber and bore should
be wiped dry. When the bore is dry, pass a slightly oiled patch
through it for preservation. A fine, light gun oil is recommended.
5 Inspect the barrel and chamber to be certain no patches have
inadvertently been left in them. Remove any that remain.
6 Use a small brush or rag to remove dirt or other foreign matter
from inside the receiver and other parts of the action. Lightly
lubricate all moving parts with a high-quality, light gun oil. Use
oil sparingly, a very light film is sufficient. A fine, light gun oil is
ideally suited for this purpose.
NOTICE! do not Pour large quantities of oil into the receiver
or other Parts. it can drain down to the wood and soften it,
causing Permanent damage and loosening of the stocK.
7 Wipe all exposed metal surfaces with a lightly oiled cloth making
certain that all finger marks are removed. Finger marks provide a
place where moisture can accumulate. The metal of the gun should
receive a light film of oil any time the rifle has been exposed to
weather or handling.
8 Wood surfaces can also be wiped with a quality, lightweight gun oil
or they can be polished with any quality furniture wax (but not both).
To Next Page
Loading...