26
CLEANING THE MAGAZINE
It is not recommended that the Double Helix
™
magazine be
disassembled. Frequently inspect magazines to determine the need for
cleaning as lubricant and dirt will gradually collect in the mechanism.
NOTICE! do not tamPer with the assemBly screw on the rear of
the magaZine. doing so will render the magaZine inoPerative.
1 Clean the magazine by spraying it with a gun cleaning solvent that
will not adversely affect the polymer magazine or corrode the
metal components. Spray the magazine with this solvent, both
inside and out, to loosen debris.
2 Fill the magazine body with plastic-safe gun cleaning solvent. Place
your finger over the loading port and shake it vigorously (with the
loading port away from you) to loosen residue in the magazine.
3 Drain the solvent and residue from the magazine.
4 Use compressed air to dry the magazine or allow it to air dry.
NOTICE! do not taKe your firearm aPart Beyond what is
exPlained in this owner’s manual. this is a sPecialiZed, finely
fitted mechanism; any attemPt to disassemBle the inner
mechanism may mar it for life. it is unnecessary, and may
do damage to the inner mechanism, to disassemBle it for
routine cleaning and oiling. of course, misfortunes
(such as droPPing your gun in water) require aPProPriate
attention, and in such circumstances we recommend you
immediately taKe your firearm to a qualified gunsmith.
To Next Page
Loading...