BRP Lynx E-TEC Series - Page 232

230
CChhaaiinnccaassee OOiill LLeevveell VVeerriiffiiccaattiioonn
With the vehicle on a level surface, check the oil level by removing the
check plug.
CCHHEECCKK PPLLUUGG
Oil level must reach the threaded hole.
If level is correct, reinstall check plug and tighten to the specified
torque.
TTiigghhtteenniinngg TToorrqquuee
Check plug 6 ± 1 Nm (53 ± 9 lbf-in)
If level is insufficient, refer to
Chaincase Filling Procedure .
CChhaaiinnccaassee OOiill RReeppllaacceemmeenntt
CChhaaiinnccaassee OOiill DDrraaiinniinngg
1. Place the vehicle on a level surface.
2. Place a drain pan under gearbox drain plug area.
3. Remove filler cap.
4. Remove the drain plug located at the bottom of gearbox.
MAINTENANCE PROCEDURES