249
track fibers are exposed, or if missing or defective inserts or guides
are noted; contact an authorized BRP snowmobile dealer.
SSnnoowwmmoobbiilleess EEqquuiippppeedd wwiitthh TTrraaccttiioonn EEnnhhaanncciinngg PPrroodduuccttss
If your snowmobile is equipped with a BRP approved studded track,
PROCEED WITH A VISUAL INSPECTION OF YOUR TRACK BE-
FORE EACH USE.
Look for any defects, such as:
– Perforations in the track
– Tears in the track (particularly around traction holes on studded
tracks)
– Lugs that are broken or torn off, exposing portions of rods
– Delamination of the rubber
– Broken rods
– Broken studs (studded tracks)
– Bent studs (studded tracks)
– Missing studs
– Studs that are torn off the track
– Missing track guide(s)
– Also, ensure that studs nut are tighten to the recommended
torque.
On approved studded tracks, replace broken or damaged studs imme-
diately. If your track shows signs of deterioration, it must be replaced
immediately. When in doubt, ask your dealer.
WWAARRNNIINNGG
RRiiddiinngg wwiitthh aa ddaammaaggeedd ttrraacckk oorr ssttuuddss ccoouulldd lleeaadd ttoo aa lloossss ooff
ccoonnttrrooll..
For complete information on traction enhancing products, refer to
TRACTION ENHANCING PRODUCTS
in
SAFETY INFORMATION
at
the beginning of this Operator's Guide.
TTrraacckk TTeennssiioonn aanndd AAlliiggnnmmeenntt
NNOOTTEE::
Track tension and alignment are interrelated. Do not adjust one with-
out the other.
MAINTENANCE PROCEDURES
To Next Page