280
TTYYPPIICCAALL
Do not touch anything during engine lubrication cycle.
The engine lubrication function takes approximately 1 minute. Dur-
ing this time the engine RPM will increase slightly to approximately
1600 RPM and the oil pump will "oil flood" the engine.
At the end of engine lubrication procedure, the ECM will turn the
engine off.
Remove tether cord cap from engine cut-off switch.
NNOOTTIICCEE
DDoo nnoott ssttaarrtt tthhee eennggiinnee dduurriinngg ssttoorraaggee ppeerriioodd..
EE--TTEECC EEnnggiinnee -- LLaarrggee PPaannoorraammiicc 77..88”” WWiiddee LLCCDD DDiissppllaayy
Follow these simple steps.
To engage the procedure, do the following:
1. Place the vehicle in a well ventilated area.
2. Start the engine and let it run at idle speed until it reaches its oper-
ating temperature (watch the coolant temperature on the display or
verify the rear heat exchanger becomes warm).
3. Using the rotary control, select the trip display but stay in odometer
mode.
STORAGE
To Next Page