EasyManua.ls Logo

BRP Lynx E-TEC Series - Page 316

BRP Lynx E-TEC Series
368 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
314
PPiilloott
llaammpp
OONN
BBEEEEPPEERR
mmeessssaaggee
ddiissppllaayy
ddeessccrriippttiioonn
snowmobile dealer. Do not
run the engine if condition
persists.
Short
beeps
repeating
rapidly
HIGH ENGINE
TEMPERA
TURE
Critical overheat. Stop
engine immediately and let
engine cool down. Check
coolant level, refer to
Maintenance
. If coolant
level is correct and
overheating persists,
contact an authorized BRP
snowmobile dealer. Do not
run the engine if condition
persists.
MUFFLER
OVERHEAT
Critical overheat. Stop
engine immediately and let
engine cool down. If
overheating persists,
contact an authorized BRP
snowmobile dealer. Do not
run the engine if condition
persists.
ECM
OVERHEAT
4 short
beeps
every
5 minutes
BATT VOLT
Indicate a low or high
battery voltage condition.
Visit an authorized BRP
snowmobile dealer as soon
as possible.
4 short
beeps
CHECK
ENGINE
Engine fault, see an
authorized BRP
snowmobile dealer, repair
shop or person of your own
choosing as soon as
possible.
Displayed when brake is
applied for more than 15
seconds while throttle lever
is squeezed and vehicle is
moving at more than 5 km/
h (3 mph).
MONITORING SYSTEM