BRP SEA-DOO Switch 13 - Page 21

21
PPrree--UUssee IInnssppeeccttiioonn
WWAARRNNIINNGG
PPeerrffoorrmm aa pprree--uussee iinnssppeeccttiioonn bbee--
ffoorree eeaacchh uussee ttoo ddeetteecctt ppootteennttiiaall
pprroobblleemmss dduurriinngg ooppeerraattiioonn.. TThhee
pprree--uussee iinnssppeeccttiioonn ccaann hheellpp yyoouu
mmoonniittoorr wweeaarr aanndd ddeetteerriioorraattiioonn
bbeeffoorree tthheeyy bbeeccoommee aa pprroobblleemm..
CCoorrrreecctt aannyy pprroobblleemmss tthhaatt yyoouu
ddiissccoovveerr ttoo rreedduuccee tthhee rriisskk ooff aa
bbrreeaakkddoowwnn oorr ccrraasshh.. SSeeee aann aauu--
tthhoorriizzeedd SSeeaa--DDoooo ddeeaalleerr aass
nneecceessssaarryy..
AAccttiioonn
√√
Make sure the hitch ball size
matches the coupler size (5 cm
(2 in)).
Check that the watercraft is
ready to be towed according to
the manufacturer's
recommendations.
Check that the jack is retracted.
Check tires condition. Refer to
Maintenance procedures for
details.
Check tires pressure. Refer to
Specifications for values.
Check of wheel lug nuts for
tightness.
Check that the load meets the
specifications.
Check that coupler is latched
and locked. Refer to
Attaching
the Trailer to the Tow Vehicle
.
Check that tongue safety cables
are crisscrossed under the
tongue and attached to the
hitch. Refer to
Attaching the
Trailer to the Tow Vehicle
.
Check lights operation.
AAccttiioonn
√√
Clean all reflectors and lights
lenses.
Check if watercraft is properly
secured to the trailer at rear.
Make sure the watercraft is
properly secured at front. Refer
to
Loading the Watercraft .
BEFORE GETTING UNDERWAY