BRP SEA-DOO Switch 13 - Page 24

24
LLOOAADDIINNGG TTHHEE WWAATTEERRCCRRAAFFTT
1. Disconnect trailer connector.
2. Have someone guiding you and
back the vehicle until the trailer
reaches the desired depth into
water.
NNOOTTEE:: Bunks should be immersed in
water just enough for the watercraft to
be dragged onto them without floating
over them.
3. Unwind the winch strap to the ap-
propriate length.
4. Align the watercraft with the trailer
bunks.
NNOOTTIICCEE
AAlltthhoouugghh tthhee bbooaatt rreeqquuiirreess oonnllyy
3300 ccmm ((11 fftt)) ooff wwaatteerr ttoo ffllooaatt,, tthhee
eennggiinnee sshhoouulldd bbee ssttaarrtteedd wwiitthh aatt
lleeaasstt 9900 ccmm ((33 fftt)) ooff wwaatteerr bbeellooww
tthhee hhuullll.. IIff tthhee ddeepptthh ooff tthhee wwaatteerr
iiss lleessss tthhaann 9900 ccmm ((33 fftt)) aanndd tthhee
eennggiinnee iiss rruunnnniinngg,, tthhee iimmppeelllleerr iiss
ttuurrnniinngg aanndd ddeebbrriiss ccaann bbee ddrraawwnn
ffrroomm tthhee bboottttoomm aanndd ddaammaaggee tthhee
pprrooppuullssiioonn ssyysstteemm..
5. Attach the winch strap to the
watercraft bow eyelet.
NNOOTTIICCEE
AAttttaacchh tthhee ssttrraapp aass eexxppllaaiinneedd.. UUss--
iinngg aannootthheerr mmeetthhoodd mmaayy ddaammaaggee
ttoo tthhee wwaatteerrccrraafftt..
6. Set winch mechanism to "wind",
then wind until the watercraft bow
reaches the trailer bow stopper
roller.
SSEETT WWIINNCCHH TTOO ""WWIINNDD""
7. Drive the tow vehicle out of the
ramp.
8. Secure watercraft on the trailer us-
ing suitable tie-downs attached to
the stern eyelets and trailer eyelets
together.
WWAATTEERRCCRRAAFFTT SSTTEERRNN EEYYEELLEETTSS
TTRRAAIILLEERR EEYYEELLEETTSS
TTIIEE--DDOOWWNNSS
9. Hook the safety strap to the front
eyelet.