30
VVeerriiffyyiinngg tthhee BBrraakkee SSyysstteemm
The brakes are hydraulic disc types.
These brakes are self-adjusting and
do not require adjustment.
To keep brakes in good condition,
check the following as per the
Mainte-
nance Schedule
:
– Entire brake system for fluid leaks
– Brake discs for excessive wear
and surface condition
– Brake pads for wear, damage or
looseness.
See an authorized Sea Doo dealer if
there are any problems with the brake
system or for servicing.
Have the brake system servicing by
an authorized Sea Doo dealer, a re-
pair shop, or a person of your own
choosing.
TTiirreess
TTiirree PPrreessssuurree
Check tire pressure. Tire pressure
must be checked while the tire is cold.
NNOOTTEE::
Do not check the tire pressure imme-
diately after towing the trailer. Allow at
least three hours for a tire to cool
down, if the trailer has been towed for
as much as 1.6 km (1 mi).
The required pressure varies accord-
ing to the trailer model. Refer to
Specifications
.
TTiirree IInnssppeeccttiioonn
Replace the tire before towing the
trailer if the tire tread has less than 1.6
mm (1/16 in) depth or if the built-in
wear indicator bars are visible and
flush with the remainder of the tire
tread.
Always replace a tire with one of the
same dimensions and load limit.
Inspect both sidewalls of each tire for
any bubble, cut or bulge; and replace
a damaged tire before towing the
trailer.
WWAARRNNIINNGG
AA bbuubbbbllee,, ccuutt oorr bbuullggee iinn tthhee ssiiddee--
wwaallll ccaann rreessuulltt iinn aa ttiirree bblloowwoouutt
aanndd lloossss ooff ccoonnttrrooll..
WWhheeeellss
WWhheeeell IInnssppeeccttiioonn
Check wheel for cracks, bumps or oth-
er damages. Replace wheel as
required.
HHuubbss,, bbeeaarriinngg aanndd sseeaallss
WWhheeeell BBeeaarriinngg IInnssppeeccttiioonn
Install a jack under the axle and raise
until the tire gets off the ground. Push
and pull the wheel from the upper
edge to feel the play and rotate wheel.
If any play is felt or if wheel does not
turn smoothly, refer to the
Mainte-
nance of hub and wheel bearing
sec-
tion bellow.
WWhheeeell BBeeaarriinngg SSeeaall IInnssppeeccttiioonn
Inspect the grease seals periodically.
A slight film of grease around the seal
is normal. Have the seal replaced if an
excessive leak or damage is noticed.
LLuubbrriiccaattiioonn SSyysstteemm
This trailer uses a Sure Lube system
on all its axles. Its advantages are as
follow:
– Check on hub and grease with
ease.
– Change the grease in the hub and
bearing (rotate slowly the hub
while putting grease in).
– Grease the bearing without taking
the hubs off.
– Grease the hub with ease, even
during a long trip.
MAINTENANCE AND INSPECTION PROCEDURES
To Next Page
Loading...