11
6) Go to the Synchronisation tab and click Synch Setup….
7) Press <F1> or click Help and follow the help given there.
To save the configuration so that it can be used by PULSE:
8) Click Apply and Save Configuration.
If it is not possible to download the latest firmware from the front
end’s home page (see “LAN-XI Firmware Update” on page 8), use the
following procedure to install the firmware version that was included
in your PULSE installation:
9) Click Firmware.
10)If the New Version and the Current Version do not match
(indicated by a yellow background in the Current Version Column),
click Start Update.
HINT: When downloading firmware to multiple modules, it is a lot faster to use the Front-end Setup program. This uses the firmware from the following
folder (can vary with language): C:\Program Files (x86)\Bruel and Kjaer\PULSE\IdaSW\PromUpdate or C:\Program Files\Bruel and Kjaer\PULSE
Reflex\idasw\PromUpdate
To Next Page
Loading...