Bruker VERTEX 70v User Manual

10 VERTEX 70v User Manual
3
INSTALLATION
Site Requirements
Vibration
Ideally, the spectrometer should not be installed near vibration sources (e.g. ventilation
hoods, air conditioners, motors, elevator etc.) or in rooms with intense floor vibration.
Power Supply
The spectrometer power supply unit automatically adapts to the most common power
sources.
Valid voltage range: 100 V AC to 240 V AC
Valid frequency range: 50 to 60 Hz
VERTEX 70v is an instrument of the protection class I.
Caution: To avoid personal injury and spectrometer damage, connect the
spectrometer only to a socket outlet with earthing contact.
To provide for good data quality and a long spectrometer service life, ensure that the fol-
lowing site requirements are met:
• Do not install the spectrometer near sources of potential inductive electrical
interference (e.g. pumps, switching motors, microwave ovens etc.), sources of
high energy pulses, and sources that might cause magnetic or radio frequency
interference.
• Do not place devices such as large electric motors, heaters, welding equipment,
radio transmitting equipment, units emitting pulsed NMRs, or high powered lasers
in close vicinity to the spectrometer. These devices can interfere with the
spectrometer and cause spectrometer malfunction. Ensure that these types of
devices are not connected to the same electrical circuit as the spectrometer.
• If a reliable mains power supply is a problem at your site (caused by brownouts,
power surges, frequent thunderstorms, for example), take precautions to ensure
an uninterruptible power supply.

Bruker VERTEX 70v Specifications

General

Brand	Bruker
Model	VERTEX 70v
Category	Measuring Instruments
Language	English