To Next PageTo Next PageHow to recall status code on Bryant 310AAV Installation, start-up, operating, and service and when LED is blinking rapidly?
To recall the status code, briefly remove and reconnect one RED wire from the draft safeguard switch of your Bryant Furnace.
What to do if Bryant 310AAV Installation, start-up, operating, and service and Furnace control does not respond to thermostat signals?
If the control does not respond to thermostat signals (W, Y1, Y/Y2 or G (24V)), run the system through a heating or cooling cycle to check its operation.
How to fix Bryant 310AAV Installation, start-up, operating, and service and Furnace if LED status light is not on?
If the LED status light on your Bryant Furnace is not on, you should check for continuity in the wire from the circuit breaker to the furnace and check for correct line voltage polarity. If the units are twinned, check for proper low-voltage transformer phasing. As other possible solutions, replace the door switch or the furnace control.
What to do if problem repeats when using a jumper wire on Bryant 310AAV Installation, start-up, operating, and service and?
If the problem repeats when using a jumper wire on your Bryant Furnace, replace the furnace control.
What to do if Bryant Furnace thermostat is not compatible?
If the thermostat is not compatible with the Bryant furnace control, install a ballast resistor, connect the Com24V thermostat terminal to the thermostat, or replace the thermostat.
Precautions to protect furnace electronic control from static discharge.
Instructions for installing the furnace in an upflow configuration.
Steps for safely starting and operating the furnace.
Procedures for adjusting gas input rate and temperature rise.
Verifying the proper function of safety controls like limit switches.
Steps and guidance for diagnosing and resolving furnace issues.
General
