To Next PageTo Next PageHow to use the Troubleshooting Guide for a Bryant 315AAV?
The Troubleshooting Guide can be a useful tool for identifying furnace operation problems. Begin at 'Start,' answer each question, and follow the arrow to the next item. This guide helps identify the problem or failed component. After replacing any component, ensure the correct operation sequence.
Where can I find a more detailed Troubleshooting Guide for my Bryant Furnace?
A more detailed Troubleshooting Guide is available from your distributor.
General| Model | 315AAV |
|---|---|
| Type | Gas Furnace |
| Blower Type | Variable Speed |
| Fuel Type | Natural Gas / Propane |
| Stages | Two-Stage |
| Blower Motor Type | ECM |
| Heat Exchanger Material | Stainless Steel |
| Ignition Type | Hot Surface Ignition |
| Efficiency Rating | High Efficiency |
| Heating Capacity | Up to 120, 000 BTU |
| Warranty | 10 years |
| AFUE | Up to 95% |
| Gas Type | Natural Gas |
| Warranty on heat exchanger | Lifetime |
Overview of the furnace, and applicable codes and standards for installation.
Procedure to prevent damage to electronic components from static discharge.
Methods for providing combustion air: Outdoor, Standard, and Combination.
Installing bottom/side return air inlets, leveling legs, and furnace support.
Installing flame roll-out protection and arranging the air filter.
General guidelines for duct systems and acoustical treatment.
Connecting supply and return air ducts to the furnace.
Warnings regarding electrical shock and guidelines for 115-volt wiring.
Connecting EAC and humidifier accessories to the furnace.
Follow safety codes for proper vent sizing and installation.
Impact of appliance operation on venting system performance.
General steps and warnings for starting up the furnace.
Procedures for testing furnace safety controls like limit switches.
A checklist for ensuring all steps are completed before operation.
Adjusting gas input rate and manifold pressure for proper operation.
Setting temperature rise and airflow for cooling and continuous fan.
Procedure for running the furnace's component self-test.
Critical safety warnings before performing maintenance or service.
Instructions for cleaning or replacing the air filter and blower motor.
Description of two-stage heating with single and two-stage thermostats.
Furnace operation during cooling, Thermidistat, and dehumidify modes.
Furnace operation with heat pump and component testing procedures.
