STANDARD FEATURES AND FIELD-INSTALLED ACCESSORIES
STANDARD FEATURE/FIELD-INSTALLED
ACCESSORY
HIGH WALL
SYSTEMS
(619B,D)
Internal Condensate Pump A
Mounting Brackets S
Microprocessor Controls S
Cleanable Filters S
3-Speed Indoor-Fan Motor S
Automatic Indoor-Fan Speed Control S
Extensive Diagnostics S
Wireless Remote Controllers S
Fully Insulated Indoor Unit Cabinet S
Automatic Air Sweep S
Auto. Restart Function S
24-Hour Automatic Start/Stop Timer S
Refrigerant Line Turn Elbow* S
High- and Low-Voltage Terminal Blocks (Indoor) S
AccuRaterT Refrigerant Metering Device S†
Manual Defrost** S
Demand Defrost** S
Warm Start (in heating)** S
Heating Operation to −20 F** S
Auto. Changeover from Cooling to Heating** S
Evaporator Coil Freeze Protection S
Outdoor Low-Voltage Terminal Block S
Accumulator S
Crankcase Heater (Reciprocating Compressor Units) S
Crankcase Heater (Scroll Compressor Units) A
High-Pressure Switch* S
Low-Pressure Switch* S
5-Year Compressor Warranty S
Compressor Start Assistance (non-scroll units) S
Cycle-LOC™ Device* S
Suction and Discharge Service Taps†† S
Totally Enclosed Fan Motor S
Acoustically-Lined Compressor Compartment S
Winter Start Control* A
Low Ambient Temperature Controls (down to −20 F)† A
Time GuardT Cycle Protector* S
Liquid Solenoid Valve* A
Condensing Unit Wall Mount Kit A
LEGEND
A—Field-Installed Accessory
S—Standard from the Factory
*For size 018 and larger.
†Not used on 38HDS systems.
**Heat pump systems only.
††The outdoor units are equipped with 4 taps; one for each service valve, and one each
on compressor suction and discharge.
3
To Next Page
Loading...
