17
Other Functions
The following functions are configured using the Contrio Default Control Panel
from within Audio Architect.
Sleep Function
When enabled, the Sleep function allows the Contrio controller's LEDs and
displays to 'sleep' (turn off) after a specified period of operator inactivity, which
can be entered in the 'Sleep Delay' field. Any button press or rotary movement
by the operator will 'wake up' the controller and restore the display and LEDs
to show current system status. Note that there is a 2 second delay after 'wake
up' before the controls will again become active.
If the 'Lockout On Sleep' function is also enabled, then, when the controller
'wakes up', it will automatically enter its 'locked' state. Button and rotary
actions on the unit will have no effect until the required security PIN number is
entered, see 'Lockout Active Function' on page 18 for further information.
To wake a controller:
1. While the controller is in the 'sleep' state, either press a button or turn
the rotary encoder.
NOTE: Although the EC-V controller cannot be unlocked directly from the
controller, it can be unlocked by other means – such as by using Soundweb
London logic or a Control Input contact closure.
Sleep Delay Time
When the Sleep function is enabled, this field allows you to enter the amount
of time it will take, after no operator activity, before a Contrio controller will go
to 'sleep' by extinguishing its LEDs.
Lockout On Sleep Function (Excludes EC-V Model)
When 'waking' a 'sleeping' controller, this function locks out the controller
until the correct PIN has been entered, see 'Lockout Active Function' on page
18 for further information.
To Next Page
Loading...