13
Entering names and numbers
There are three lines in your
display for entering information.
1st line for the name (maximum
16 characters) 2nd and 3rd lines
for the number (maximum 32
characters)
Upper and lower case
• Press the
*
button to switch
from lower to upper case for one
character.
Controlling the cursor
• LEFT/RIGHT BUTTONS are used
to move the cursor to the right
and left. When you have entered
the name, move the cursor to
the right until it goes to the next
line where the number can be
entered.
Letters are entered by pressing
the relevant button repeatedly.
For example, to store the name
JOHN:
• Press and hold
5 on the keypad
until J appears in the display.
• Then press and hold
6 on the
keypad until the display shows O.
• Enter the H by pressing and
holding
4 on the keypad until H
appears on the display.
• Press and hold
6 on the keypad
until N appears on the display.
The whole name is now entered.
4
GHI
5
JKL
6
MNO
#
<
>
Delete
Press the CLEAR CHARACTER
button to delete the character to the
left of the cursor. Hold down the
button to keep deleting characters
automatically.
Insert
Characters are inserted to the left
of the cursor. Position the cursor
and add the character required.
To dial a number stored in
the Directory
• Press the DIRECTORY button to
open the phone book.
• Press the
DOWN button to scroll
through the names or find the
required name by using the keypad
to enter the first letter of the name.
• Press the
PHONE button to dial
the number.
Quick search for a Directory name
When you have accessed the Phone
Book it is possible to make a quick
search to a listed name.
• Press
DIRECTORY option.
• Press the button with the first letter
of the name you wish to call.
The display will now highlight the
first name in the address book that
starts with that letter. If this is the
correct name press
PHONE to dial.
Or
Use the
DOWN option to move to the
correct name, then press
PHONE.
▲
➜
▼
▼
To Next Page
Loading...
