When using the handset or
a headset:
Press the Amplify button.
Press the VOL + or VOL -
button to increase or
decrease the volume of
your caller’s voice.
To store a one-touch
number in the memory
Your Converse 320 can
store up to 20 telephone
numbers: 10 one-touch
numbers under the
memory buttons and 10
two-touch numbers, using
the memory buttons with
the Shift button.
Stored numbers can be up
to 21 digits long and
include the ✱ and #
buttons and a pause.
Use the label to keep a
directory of each one-touch
and two-touch number.
One-touch memory buttons
6-10 (the bottom 5 buttons)
are pre-set with BT Select
Services numbers (see
‘Using Select Services’).
These can be overwritten if
you wish.
Press the Store button.
Press the Memory button
under which you want to
store the number.
Enter the phone number
you want to store.
Press the Store button.
The number is stored.
To change a stored number,
repeat the steps shown
above. The new number
will replace the existing
one-touch number.
To dial a
one-touch number
Press the Handsfree button
and press the memory
button you want.
The number is dialled.
To store a two-touch
number in the memory
Press the Store button.
Press the Shift button.
Press the Memory button
under which you want to
store the number.
Enter the phone number
you want to store.
Press the Store button.
The number is stored.
To dial a
two-touch number
Press the Handsfree button.
Press the Shift button.
Press the Memory button
you want.
The number is dialled.
To store a number
longer than 21 digits
Store the first 21 digits as
shown previously, then
repeat the steps to store
the remaining digits under
another Memory button.
To dial a stored
number of more than
21 digits
Press the Handsfree button.
Press the Memory button
which contains the first 21
digits.
Press the Memory
button which contains the
remaining digits.
The number is dialled
automatically.
eg
eg
eg
eg
1
2
3
1
2
1
1
2
3
4
5
1
2
3
1
2
3
To Next Page
Loading...
Need help?
General
