4
Essential Phone Single
090657
090713
Quick set-up guide
Where to put your phone
• Place the base within 3 metres
of a mains power socket and 1.8
metres of a phone socket
so the cables will reach.
• Make sure it’s at least a metre
away from other electrical
appliances to avoid interference.
• Don’t place the phone or
base in a bathroom or other
humid area.
• The product works by sending
radio signals between the
handset and base. The strength
of the signal depends on where
you position the base. Putting it
as high as possible can help give
you the best signal.
1. Plug in
1. Plug the mains power adaptor
into the base, with the cable clipped
in the groove provided.
2. Plug the other end of the power
adaptor into the wall power socket
and switch on.
The phone line cord is pre-installed
but don’t plug the other end into
the wall socket yet.
Important
• Don’t connect the phone line to
a phone socket until the handset is
fully charged.
• The base station should be
plugged into the mains power
socket all the time.
21
To Next Page
Loading...
