BT Hub Phone 2.1 - Page 4

For more detailed instructions and troubleshooting, please see page 12.
2
Check box contents.
BT Hub Phone 2.1
8
Place the Hub Phone in its cradle and leave it to
charge for 24 hours before making any calls.
4
When Register handset to your Home Hub
appears on the handset screen, press OK.
OK
Register handset
to your Home Hub
6
Press OK on your Hub Phone. Registering. Please
wait. will appear on the handset screen, followed
by Handset registered.
1
Set up your BT Home Hub 2.0 and check that its
Phone light is glowing steady blue. If the Phone
light isn’t steady blue, see page 11.
7
Attach the charging cradle to the Hub by pulling
the Hub’s grey front cover towards you, and then
push the charging cradle in to attach it.
The rechargeable batteries are already installed.
Pull the plastic tab away from the handset to
activate them.
3
5
Press the Wireless Association button on the side
of your Hub. The phone and wireless lights will
start ashing.
Quick Start Follow these simple steps to set up your BT Hub Phone 2.1
Find out more For more information on using your Hub Phone around your home, including making great-value calls using BT Broadband Talk, please see page 7.
Find HandsetReset to
Defaults
Wireless
Association
Restart
1
2
Press and release
the Wireless
button on the Hub
OK Back
Registering.
Please wait.
Handset
registered
1
2
3
AAA Ni-MH rechargeable
batteries (x2)
pre-installed in handset
User Guide
Charging
cradle
Power adapter (not
required when cradle
is attached to Hub)
Note: the position of the pull out tab may be different
on some phones