Need help?Do you have a question about the Bticino 363911 and is the answer not in the manual?
Details on existing 3-wire doorbell systems.
Describes new systems using 2 wires without modifications.
Illustrates wiring for single-family installations.
Specific wiring diagram for bifamiliar systems.
Specific wiring diagram for bifamiliar systems.
Details on the relay door lock feature and its operation.
Physical dimensions of the entrance panel and internal unit.
Step-by-step guide for installing the entrance panel.
Recommendations for camera placement and environment.
Steps to resolve audio feedback issues.
Specifications of the wireless communication device.
Configuration settings for the entrance panel.
Procedure for programming the master badge.
Information on managing administrator credentials.
Steps to program the system management key card.
Procedure for removing master badge access.
Instructions for programming resident badges.
Procedure to remove all resident badges from memory.
Steps to perform a full system reset.
Guide for installing the internal unit handset.
Safety and operational guidelines for internal unit mounting.
Guide for installing the optional table-top base.
Importance of checking Wi-Fi signal before installation.
How to verify Wi-Fi signal strength and quality.
Details on device address and configuration modes.
Assigning functions to the preferred key via physical configuration.
Steps for the initial power-on and setup.
Guide for choosing the interface language.
Instructions for configuring date and time.
Important considerations for remote operation.
Guide to configure Wi-Fi network settings.
Explains the function of the door state indicator LED.
Details on how to set up automatic door lock opening.
How to send voice messages via the intercom.
Instructions for using the teleloop and positioning.
Shows how to wire for staircase lighting control.
Shows how to wire an additional bell.
To Next Page
General