To Next PageTo Next Page
Need help?Do you have a question about the BU-KO power PGBC-5200 and is the answer not in the manual?
Details of the authorised distributor, address, and contact information.
Explains the manual's purpose and stresses the importance of safety precautions.
Essential rules for safe operation, including protective gear and environmental conditions.
Explanation of various hazard and warning symbols used in the manual.
Further explanation of safety symbols related to entanglement, hot surfaces, and wildlife.
Key advice and reminders for safe operation and manual handling.
Conditions to avoid and guidelines for planning work sessions.
Precautions before starting and detailed steps for starting the engine.
Proper techniques for holding and using the brush cutter.
Safety measures concerning bystanders and potential hazards.
Safe practices for refueling and importance of regular maintenance.
Visual identification of all parts included with the brush cutter.
Crucial information about mixing fuel and oil at a 40:1 ratio.
Pre-use inspection checklist and details on locking washers and hub.
Step-by-step guide to attaching the handle and lower guard.
Procedure for connecting shaft sections, aligning splines, and securing the joint.
Steps for aligning components and locking the axle for blade installation.
Diagram showing washers, blade, and nut for installation.
Procedure for fitting the washer and the 3-tooth blade correctly.
Steps to secure the blade with washer 'B' and tighten the locking nut.
Fitting washer 'A' and attaching the spool housing to the shaft.
Overview of the harness, its comfort features, and adjustability.
Step-by-step guide on how to put on and adjust the harness for proper fit.
Instructions for attaching and detaching the machine using the quick release hook.
Procedure for filling the fuel tank with the correct fuel mixture and priming.
How to use the choke for cold and warm engine starts.
Enabling power and preparing the recoil starter for ignition.
Detailed steps for starting the engine using the recoil starter.
Allowing the engine to idle and cool down before shutdown.
Procedure for turning off the engine using the on/off switch.
Diagram of spool parts and basic operation for line feeding.
How to attach the spool to the hub and feed the line.
Steps to open the spool cover and remove the cartridge.
Procedure for winding the trimmer line onto the cartridge.
Maintenance schedule for the complete machine and cutting attachments.
Initial maintenance tasks for engine components like air filter and fuel pump.
Instructions for adjusting the slack or tension in the throttle cable.
How to fine-tune the engine's idling speed.
Techniques for efficient trimming of grass and weeds.
Optimal cutting techniques and selecting the right blade for the task.
How to advance the trimmer line while operating.
Understanding and managing blade thrust for safety.
Guidelines for safely moving the brush cutter between work areas.
Solutions for common issues when the engine fails to start or runs poorly.
Resolving issues with engine speed, smoke, idling, and spool unwinding.
Troubleshooting for blade rotation, excessive vibration, and installation.
Specific maintenance tasks for engine parts like Carburettor, Spark Plug, etc.
Details regarding the product's 12-month guarantee against defects.
Formal statement of compliance with relevant EU directives and standards.
General| Engine Type | 2-Stroke, Air-cooled |
|---|---|
| Displacement | 52cc |
| Cutting Width (Blade) | 255 mm |
| Weight | 7.5kg |
| Shaft Type | Straight |
| Fuel Tank Capacity | 1.2 liters |
