ASSEMBLY
1. Assemble No.1 wind pipe (15) to the flexible pipe (13) by turning it
counter-clockwise then screwing the clamp (B)
2. Assemble flexible pipe (13) to flexible elbow (12) on blower by screwing
the clamp (A1)
3. Loosen wing nut (C) completely by hand then install handle with switch (D)
on the No.1 wind pipe (15) by sliding notches (E) in handle clamp; handle
should be angled away from operator.
4. Position handle for comfortable operation and screw wing nut (C) tightly.
5. Assemble No.1 wind pipe (15) to No.2 wind pipe (16)
6. Assemble No.2 wind pipe (16) to No.3 wind pipe (17) and fix it with the top
screw.
Adjusting backpack and harness and control handle
1. Place blower on your back by slipping arms through the shoulder straps as
if you were putting on a backpack.
2. Once adjustments have been made to the straps for user comfort, remove
the blower from your back and place on level ground in an upright position.
3. Adjust backpack harness and control handle.
Comment [1]: A2 及上面的金属卡件 PS
掉
To Next Page
Loading...