Bubble Magus C3.5 - Page 2


6. Aftercompleteassembly,theunitisreadyforuse. 
a. Submergetheunitwithwater
b. Connectpowercordtoanelectricsocket(GFIcertifiedoutlet).
c. Makeyouradjustmentsusingtheadjustmenttube.

Maintenance:
1. Servicethecollectioncupandtheneckregularly.
2. Disassembleandcleantheventuriandpumpevery3to6months.
a. Disassemble,inspect,andcleantheimpellertomaximizelifeandperformance.
3. Acompleteskimmercleaningisrecommendedevery6to12months.
4. Avoidusingharshcleaningchemicalsandsoaps.A50/50vinegarbathis
recommended.

FurtherComments:
1. Donotrunthepumpdry.Makesurethatitissubmergedalreadybeforeoperation.
2. Aftersuccessfulinstallation,bubbleswillappearwhenthepumpisactive.Otherwise,
restartthesystem.IftheproblempersistthencontactSeaSideAquaticsforsupport.
3. Newskimmersmayrequireabreakinperiodofafewdaysormore.
4. Suggestedexternalwaterlevelis2025cm. 
5. Eachunithasbeenpretestedatthefactorytoensurethattheunitisinworkingorder.
Sometracesofwaterisnormal;theunitandallofitscomponentsarenew. 
