This means that when the required water temperature is achieved it will not be possible to
turn the flame up via the oil flow control knob because the water temperature control has
taken priority.
3
3
L
L
I
I
G
G
H
H
T
T
I
I
N
N
G
G
A
A
N
N
D
D
A
A
D
D
J
J
U
U
S
S
T
T
I
I
N
N
G
G
When attempting to light the stove these are the rules, which must be followed.
1.Always make sure that the pot is not flooded with oil by looking down into the base of the
pot.
2.Never try to light the stove if it is flooded with oil.
3. Always check that oil has not leaked and settled under the pot
4.Do not light the stove and leave it until it is settled down and stabilized into blue flame
combustion on low fire. (This will take 10 to 20 minutes.)
T
T
H
H
R
R
E
E
E
E
W
W
A
A
Y
Y
S
S
T
T
O
O
L
L
I
I
G
G
H
H
T
T
T
T
H
H
E
E
S
S
T
T
O
O
V
V
E
E
1. Through the lighting port.
2. Through the front door, directly into the base of the pot.
3. Via Electric ignition kit. (Optional extra)
L
L
I
I
G
G
H
H
T
T
I
I
N
N
G
G
I
I
N
N
T
T
O
O
T
T
H
H
E
E
B
B
A
A
S
S
E
E
O
O
F
F
T
T
H
H
E
E
P
P
O
O
T
T
On the first light up you may find the first option easier, as you can see the oil trickle in to the
pot more easily.
You must use a heatproof glove when putting the catalysers back into the pot and it is important
to replace them quickly whilst the flame is small.
1. Make sure that the oil is turned off.
2. Open the front door.
3. Carefully remove the coal kit,
4. Remove the upper catalyser and ring,
5. Remove the lower catalyser,
6. Turn the oil on and allow a small pool of oil to flow into the pot about the size of a small
biscuit,
then turn the oil off
7. Light a small piece of firelighter and drop it into the oil, allow a few seconds for it to get
going and then replace the catalysers and coal kit, and close the door.
8. Wait for approx 1 minute until the pool of oil is alight and then turn the oil on to
minimum setting no 1.
9. Watch the appliance for a few minutes and you will see the flame establish and settle
down into blue flame combustion.
10. Allow the burner to run for a further 10 minutes before turning the appliance up to the
higher settings.
11. If at any time during the ignition process large amounts of flame can be seen, turn
the oil off immediately and wait until the flames die down before putting the oil on
again at minimum setting.
To Next Page
Loading...
