Setting up the network connection between computer and NIRMaster™
In this step the communication connection between the NIRMaster™ and computer is set up.
u Start the computer, and open the dialog box Ethernet Properties.
u Highlight the option [Internet Protocol Version 4 (TCP/IPv4)] from the
list.
u Click the button [Properties].
ð The dialog box Internet Protocol Version 4 (TCP/IPv4) open.
u Activate the radio button next to [Use the following IP address].
u Enter the following values.
• IP address: 192.168.1.2
• Subnet mask: 255.255.255.0
u Click the button [OK].
ð The dialog box Internet Protocol Version 4 (TCP/IPv4) close.
u Click the button [OK].
ð The dialog box Ethernet Properties close.
The network settings are now correctly set up so communication between the NIRMaster™ and computer is possible.
Start NIRWare operator software and verify that the Computer is correctly connected to the NIRMaster™.
NIRMaster™ Supplement Installation ManualBÜCHI Labortechnik AG
To Next Page
Loading...
