6 Operation
33 V-850/855 Operation Manual, Version A
6.7.1 Mode
Depending on the controller you are working with, several modes are available, enabling you to work
in different environments and use different programs, see chapter 4.2.
6.7.2 Options
The submenu Options contains the same system confi guration screens as the Wizard and the Wizard
itself. From the submenu Options you can access the confi guration screens Options Controller,
System confi guration, Confi guration AutoDest, Control Rotavapor individually, while, when entering the
Wizard, you are guided through the confi guration screens step by step, see also chapter 5.4.
6.7.3 Program
The program submenu only contains programs, if you have previously defi ned and saved programs
yourself. Programs can be defi ned within the Gradient, the Timer and the Repeat mode. In the
following, the program defi nitionis shown, considering the Gradient mode as example.
Defi ning a program
To defi ne a program in the Gradient mode, proceed as follows:
Press Prog. on the main screen. The following screen appears:
Fig. 6.10: Step 01
To defi ne a new program, press New. You are now in the edit mode, where you can defi ne the
individual settings and save your changes.
Fig. 6.11: Step 01
•
•
To Next Page
