EasyManua.ls Logo

Buck BUCK-Libra Plus LP-5 User Manual

Buck BUCK-Libra Plus LP-5
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
A.P. BUCK, INC.
7101 Presidents Drive Suite 110 Orlando, FL 32809 USA
Tel 1-800-330-2825 407-851-8602
Fax 407-851-8910
apbuck@apbuck.com www.apbuck.com
MAN-LIBRA PLUS
Dated : February 8, 2006
BUCK-Libra Plus
MODEL LP-5
7101 Presidents Drive Suite 110 Orlando, FL 32809
Tel: (407) 851-8602 Fax: (407) 851-8910
apbuck@apbuck.com www.apbuck.com
INSTRUCTION
M
ANUAL
Question and Answer IconNeed help?

Do you have a question about the Buck BUCK-Libra Plus LP-5 and is the answer not in the manual?

Buck BUCK-Libra Plus LP-5 Specifications

General IconGeneral
BrandBuck
ModelBUCK-Libra Plus LP-5
CategoryWater Pump
LanguageEnglish

Summary

Quick Start Guide

Setting Pump Flow Rate

Step-by-step guide to adjust and set the pump's flow rate.

Service and Support Information

Repair and Warranty Service

Details procedures for out-of-warranty repairs and required information.

Pump Specifications

Flow and Compensation Ranges

Details the pump's operational flow ranges and compensation capabilities under varying back pressures.

Operation Displays

LIBRA PLUS OPERATION DISPLAYS (Continued)

Flow Fault Displays

Explains error messages for flow faults like blockage or filter disconnection and retry attempts.

Battery Chargers and A/C Power Supply

LIBRA PLUS OPERATIONAL MENUS

Calibration Mode

Explains how to verify and adjust flow rate against a calibrator.

Low Flow Tube Sampling

Setup for Low Flow Sampling

Guidance on setting up the pump and sorbent tubes for flows between 5 to 800 cc/min.

Low Flow Sampling Procedure

Step-by-step instructions for sampling with adsorbent tubes using a calibrator.

Filter Cassette Sampling

Setup for Filter Cassette Sampling

Instructions on connecting a filter cassette to the pump before setting flow rate.

Flow Rate Adjustment

Steps to set and adjust the pump's flow rate for filter cassette sampling.

Pump Calibration Adjustment

Procedure to measure and adjust flow rate using a calibrator for accuracy.

Bubbler and Impingers Sampling

Sampling Train Setup

Guidance on assembling the sampling train including pump, cassette, and bubbler.

Bubbler/Impinger Sampling Procedure

Instructions for setting flow rate and conducting sampling with bubblers or impingers.