Buckingham 574 User Manual

BUCKINGHAM MFG.
PN 574 Staple Stick
Instructions and Warnings
Note: Color may vary from that shown.
• PN 574 Staple Stick (Fig. 1a) will hold 12 staples of varying diameter (0.140” – 0.150”) up to 7/8” wide.
• PN 574L Large Staple Stick (Fig. 1b) will hold 10 staples of varying diameters (0.150” – 0.162”) up to 1” wide.
(Recommended minimum staple diameter of 0.140” for PN 574 and 0.150” for PN 574L)
Loading Staples:
1. Align the staple with the slot (Fig. 2)
2. Insert the staple into the slot until the tips are flush with the opposite side (Fig. 3 – 5)
Note: Keeping the staple points inside the slots of the stick help to prevent snags and accidental puncture of equipment and
person.
Use:
1. Align the staple over the wire or conduit (Fig. 6).
2. Gripping the stick with your hand and away from the staple being used, strike the staple with the hammer starting it into
the pole (Fig. 7).
3. Pull the stick away (leaving the staple in the pole) and continue to hammer staple to desired depth (Fig. 8).
Note: Extra staples have been removed for clarity.
574 – 574L Staple Stick Inst-Warn.Doc (Rev. 4/20/18) 1 of 2
PN 230423
½” Diameter
Attachment Hole
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Tips of staple are flush
with base of stick
Grip stick away from
staple being used
Wire / Conduit
Pole
Staple slot
(x12)
Wire / Conduit
Fig. 1a
Fig. 1b

Buckingham 574 Specifications

General

Brand	Buckingham
Model	574
Category	Security Sensors
Language	English

Summary

Loading Staples

Using the Staple Stick

Storing the Staple Stick

Inspecting the Staple Stick

Safety Warnings

Cleaning and Storage