20
DP12VL
MAINTENANCE
ROUTINE INSPECTION
Before each use, inspect the general condition of the tool. If any of these following
conditions exist, do not use until parts are replaced.
CHECK FOR:
• Loose hardware or improper mounting,
• Misalignment
• Damaged cord/electrical wiring,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation
CAUTION:
Most plastics are susceptible to damage from various types of commercial solvents.
Do not use any solvents or cleaning products that could damage the plastic parts.
Some of these include but are not limited to: gasoline, carbon tetrachloride, chlorinated
cleaning solvents, and household detergents that contain ammonia.
CLEANING & STORAGE
1. After every operation, use a vacuum to remove sawdust or metal shavings from the
tool surfaces, motor housing and work area. Keep the ventilation openings free from
dust and debris to prevent the motor from overheating.
2. Wipe the tool surfaces clean with a soft cloth or brush. Make sure water does not get
into the tool.
3. Apply a light coat of paste wax to the column and table to help keep these surfaces
clean and rust free.
4. Store the tool in a clean and dry place away from the reach of children.
LUBRICATION
The ball bearings in the spindle and the V-belt pulley assembly are greased and
permanently sealed, and require no lubrication. Pull the spindle down and oil the quill
moderately every three months.
Lubricate the table bracket and locking knobs if they become difficult to use.
PRODUCT DISPOSAL
Used power tools should not be disposed of together with household waste. This
product contains electronic components that should be recycled. Please take this
product to your local recycling facility for responsible disposal and to minimize its
environmental impact.
To Next Page
Loading...
