3
UK
Cleaning, Care & Maintenance
1. Remove the inner bowl and wash in warm, soapy water. Do not use harsh abrasive cleaners or
products that are not recommended for use on non-stick coatings.
2. Rinse and dry thoroughly.
3. Clean the exterior of the rice cooker with a damp cloth.
4. Ensure the heating plate is clean and free of food or other debris that could interfere with the cooking
process.
5. Dry the heating plate thoroughly before use.
J300 Only
1. Remove the water collector from below the lid hinge by pulling
outwards [Fig. 1]. Discard the water collected after each use.
2. Clean and replace the water collector.
Tro ubles hooting
Note: Always switch off and disconnect the appliance from the power supply before
cleaning.
Always allow the appliance to cool before cleaning.
Fault Probable Cause Action
The unit is not
working
The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug and lead are damaged Call BUFFALO agent or qualified technician
Fuse in the plug has blown Replace the plug fuse
Power supply Check power supply
Internal wiring fault Call BUFFALO agent or qualified technician
The bowl is not in contact with the
heating plate
Realign bowl
Rice is not thoroughly
cooked
The bowl is not in contact with the
heating plate
Reposition bowl
The bowl has become deformed Replace bowl
Not enough water Increase the amount of water used
Rice is overcooked Too much water Decrease the amount of water used
Fig. 1
To Next Page
Loading...