BUFFBEE RS11 - Getting Started and Initial Setup; Initial Power and Battery Setup; Important Usage Notices

5
1. Plug the adaptor into a standard household outlet, you
will see 12:00 on the display and the clock is ready to
be set.
2. Please remove the battery tab before use.
Getting Started
Notice：
• If the display is “blank” after plugging in, please check
whether the DISPLAY DIMMER on the back is at the
HIGH position.
• Under the battery power, the display will go blank and
preset alarm will not go off. Battery backup is for
saving TIME and ALARM settings only.
• Please extend the FM antenna on the back of the
clock.
• If you press any button, all the buttons will light up and
then turn off automatically after 5 seconds.