f Raise the handlebar. The chassis is now in the
2-wheel position.
step 2 fitting the seat
a. Apply the parking brake.
b. Lay the chassis on the floor with the frame bearers
facing upwards.
c. Completely fold out the seat’s 2 frame supports.
d. Place the seat on the frame bearers.
e Push until you hear a ‘click’ on both sides. The seat is
now attached to the chassis.
f Lift the handlebar up and place the seat in the correct
position.
g. Allow the handlebar to go down. Now place the child
in the seat.
h. Fasten the 5-point harness.
To Next Page
Loading...
