Securing child
Use infant inlay
We recommend using the full infant
inlay while the baby is under 60 cm
or until they outgrow the inlay.
The infant inlay increases side
impact protection.
Remove the infant inlay
side wings when the
infant’s shoulders no
longer fit comfortably.
After the child is placed into the seat, check whether
the Shoulder Harness Straps are at proper height.
1 While pressing the harness adjustment button,
pull completely the two Shoulder Harness Straps
of the enhanced child restraint. (22)
2 Unlock the buckle of the harnesses by pressing
the red button. (23)
3 Place the child into the infant carrier module and
lock the buckle. (25) Please refer to (24).
4 Tighten the shoulder harness straps by pulling
the adjustment webbing. (26)
Make sure the space between the child and the
Shoulder Harness Straps is about the thickness
of one hand.
Canopy
1 Flip out visor from underneath the front canopy
bow. (27)
2 Pull out the extendable ‘smart visor’ from in
between the two visor layers. (28)
3 Attach the magnets on each corner to the front of
the child seat. (29)
4 The Peek-a-boo on the back can be opened for
ventilation. (30)
To fold back the canopy, rst ip back the visor
underneath the front canopy bow and then fold
back the extendable smart visor underneath.
Detach & assemble soft goods
see images (31)-(40)
To re-assemble the soft goods, reverse the
aforementioned steps.
Installation without base
1 DO NOT install this infant carrier module on
vehicle seats with Lap Belts. (41)
2 This infant carrier module is suitable for vehicle
seats with a 3-point Retractor Safety Belt (without
base) only. (42)
3 Place the infant carrier module onto the vehicle
seat where you wish to put it. Pull the vehicle
18 19
BGB Turtle Air EMEA Book A6 IMG-0119F-1.indb 18-19BGB Turtle Air EMEA Book A6 IMG-0119F-1.indb 18-19 20-08-2020 19:4420-08-2020 19:44
To Next Page
Loading...
Need help?
General