#360 Grain Cleaner
- 7 -
OPERATION OF CLEANER
The Cleaner will remove both fine seeds and chaff as well as larger trash such as corn
cobs or stalks.
A 6" utility auger is recommended as an intake auger. A 1 hp electric motor should be
used to run both the cleaner and the utility auger. These must be supplied by the
purchaser of the cleaner.
Adjust the height of the legs on the front frame to the position which will give you
maximum capacity.
A variety of screens are available to fit your needs.
Belt tension should be periodically checked and any trash should be removed from the
pulley grooves.
The cone flow control must be set to minimize grain loss through the trash outlets.
Capacity will vary with type of grain and moisture content. A flow control on the intake
auger will allow you to match input to cleaner capacity.
The cleaner should be run until empty before stopping. Do not leave grain in cleaner or
start the cleaner with a load of grain in it.
Tires provided with cleaner are for low speed towing only.
Keep all shields in place while cleaner is running. Stop cleaner to make any
adjustments.
The rotation direction when viewed from the motor drive end should be as shown in the
drawing below.
To Next Page
Loading...