Why is too little melt discharged from my Buhnen Melting Machine?
If too little or no melt is discharged from your Buhnen Melting Machine, the stock temperature might be too low. Try raising the temperature.
What to do if the nozzle keeps dripping on my Buhnen Melting Machine?
If the nozzle of your Buhnen Melting Machine drips, it could be due to a partially obstructed or damaged nozzle valve. To resolve this, drain the device, actuate the trigger for about 5 seconds to clear the nozzle, and then clean or replace the nozzle end.
How to fix a clogged nozzle system on Buhnen Melting Machines?
If too little or no melt is discharged from your Buhnen Melting Machine, the nozzle system might be clogged. Try cleaning or replacing the cone nozzle, and if needed, the nozzle end.
What to do if Buhnen Melting Machine discharges too little melt?
If too little or no melt is discharged from your Buhnen Melting Machine, the operating pressure may be too low. Increase the operating pressure to a maximum of 6 bar.
Why is compressed air escaping from the service unit of my Buhnen Melting Machine?
If compressed air escapes from the service unit of your Buhnen Melting Machine, the connections might not be airtight. Tighten the connections or replace the gaskets to fix this.
What to check if my Buhnen Melting Machine is not discharging melt?
If too little or no melt is discharged from your Buhnen Melting Machine, ensure that the compressed-air supply is properly connected and functioning.
How to fix Buhnen Melting Machines controller that won't turn on or off?
If the controller of your Buhnen Melting Machine cannot be switched on or off, the micro switch at the trigger might be continuously activated or defective. Eliminate any deadlock at the micro switch (sheet metal tongue) or replace the micro switch.
What causes compressed air to escape from the service unit of Buhnen HB 710 HT Melting Machines?
If compressed air is escaping from the service unit of your Buhnen Melting Machine, the sight glass of the water separator may be cracked. Replace the sight glass to resolve this issue.
How to resolve compressed air escaping from Buhnen Melting Machine service unit?
If compressed air escapes from the service unit on your Buhnen Melting Machine, the nozzle system may be clogged or damaged. Clean or replace the swirl nozzle, pressure spring, and ball.
Why is compressed air escaping from the closure cap (11) of my Buhnen Melting Machine?
If compressed air escapes from the closure cap of your Buhnen Melting Machine, it could be due to insufficient cover pressure. Try increasing the cover pressure.
General| Voltage | Unknown |
|---|---|
| Melting rate | 1.5 kg/h |
| Power | 0.7 kW |
| Melting Capacity | 1.5 kg/h |
| Power Consumption | 0.7 kW |
To Next Page