To Next Page
T
Tara FoxAug 8, 2025
What to do if Buhnen HB 720 R/S nozzle goes on dripping?
- NnancyfrederickAug 8, 2025
If the Buhnen Tools nozzle is dripping, here are several possible solutions: * Clean or replace the nozzle end. * Increase the operating pressure, but do not exceed the maximum of 6 bar. * Check the compressed-air supply. * Clean or replace the cone nozzle and, if necessary, the nozzle end. * Raise the temperature. * Increase the cover pressure. * Tighten or replace the gaskets.
General