TEMP (Temperature):
To
manually adjust the
temperature inside the vehicle, press the up arrow on
the TEMP control
to
raise the temperature and press the
down arrow to lower the temperature. The display will
show your selection for a few seconds, and then
the outside temperature will be displayed.
When the DUAL light indicator
is
on, this means the
TEMP control has set the temperature for the driver.
When the DUAL light indicator light
is
not
on,
this
means
the TEMP control has set the temperature for the
entire cabin.
@
FAN:
Press the up arrow
on
the
FAN
control
to
increase fan speed and the down arrow to decrease fan
speed. Pressing the arrows cancels the automatic
operation and places the system
in
manual mode. Press
the AUTO button
to
return to automatic operation. If
the airflow seems
low
when the fan
is
at the highest
setting, the passenger compartment
air
filter,
if
equipped, may need
to
be replaced.
For
more
information see Passenger Compartment
Air
Filter on
page
3-26
and
Pat?
A:
Scheduled
Maintenance
Sewices
on
page
6-4.
AIR
FLOW:
This control has several setting
to
control
the direction of airflow when the system
is
not
in AUTO.
To access the various modes available, continue to
press the
AIR
FLOW
up or down arrows until the desired
mode, (listed below), appears in the display.
WINDSHIELWFLOOR:
This setting directs some of the
air to the floor outlets and some to the defroster and
side window outlets. The air-conditioning compressor will
run automatically in this setting unless the outside
temperature is below
40°F
(4°C).
MlBIFLOOR:
This mode directs airflow through both
the
floor
and the instrument panel outlets. A small
amount of air is directed
to
the windshield and the side
window outlets.
MID
(Instrument Panel):
This mode directs air through
the instrument panel outlets.
FLOOR:
This setting sends most
of
the air through the
outlets near the floor. The rest comes out of the
defroster and side window outlets.
VENT:
Press this button
to
turn the air-conditioning
compressor on or
off.
The indicator light on the VENT
mode is
lit
when the compressor is turned
off.
You may
have to adjust the interior brightness control to the
highest setting during the day in order
to
see the
indicator lamp.
VENT does not operate in the FRONT defrost mode.
3-23
To Next Page