3.
Remove the
3800
Series I1
V6
engine cover shield
to access the bleed valve.
3.2.
3.1.
Clean the area around the engine oil
fill
tube
and cap before removing. Twist the
oil
fill
tube, with cap attached, counterclockwise
and remove it.
3.3.
3.4.
If
you have the supercharged engine,
remove the nut in the center of the cover
shield.
Lift the engine cover shield at the front, slide
the catch tab out
of
the engine bracket and
remove the cover shield.
Put the
oil
fill
tube, with cap attached, in the
valve cover oil
fill
hole until you’re ready to
replace the cover shield.
5-35
To Next Page
Loading...
