Taillamps,
Turn
Signal,
and
Stsplamps
I
A
A
B
3.
Remove the three plastic wing nuts
(A).
There is one wing nut located on the outside
of
the
carpet. The other two are located underneath
the carpet.
4.
Pull the taillamp housing
(B)
away from the body
of
the vehicle.
5. Squeeze the tab on the socket and turn the socket
counterclockwise.
6.
Pull out the socket.
7.
Pull the old bulb out of the socket. (There are two
bulbs on each taillamp.)
8.
Push in a new bulb.
9.
Reverse these steps to reinstall the lamp assembly
1.
Open the trunk.
2.
If
your
vehicle
is
equipped with
a
convenience net,
remove
it.
5-55
To Next Page
Loading...
